Installation And Connection; Installation; Electrical Connection; Shielding And Cable Routing - Balluff BOS R254K-UUI-LH10-S4 Betriebsanleitung

BOS R254K-UUI-L_1_-S4
Photoelectric Sensors
5

Installation and connection

5.1

Installation

For dimensions, see Fig. 4-1 on page 7.
CAUTION
Visible laser radiation
If you look into the laser beam, temporary blinding and
irritation of the eyes is possible. The use of operating
elements or the implementation of settings or processes
which are not described in this user's guide may cause
dangerous radiation exposure.
► Locate sensor so that it is not possible to look into
the laser beam even during operation.
► Take specifications in this user's guide into
consideration.
The sensor can be fastened with two M4 screws.
Plug outlet direction:
Fig. 5-1: Example image of use with angled connector
8 english
5.2

Electrical connection

1
2 4
3
Fig. 5-2: Plug layout (top view of M12 plug on BOS)
Pin Signal
1 L+ (Operating voltage +, SIO 10...30 V,
IO-Link 18...30 V)
2 ...-LH10-...
I/Q (Digital input / digital output / analog output)
...-LH11/LK10/LE10/LS10-...
I/Q (digital input / digital output)
3 L− (Operating voltage −)
4 C/Q (IO-Link communication / digital output in SIO
mode)
Tab. 5-1: Pin assignment
Factory setting
– Mode: SIO mode
– Object recognition operating mode: Standard
– PIN 2: Switching output (push-pull)
– PIN 4: Switching output (push-pull)
Also see document IO-Link configuration under
www.balluff.com on the product page.
5.3

Shielding and cable routing

Cable length
For IO-Link operation, the maximum cable length is 20 m.