Startup; Starting Up The System; Operating Notes - Balluff BCM R15E-00 DI00 S4 Serie Betriebsanleitung

BCM R15E-00 _ -DI00-_ _ , _-S4
Condition Monitoring Sensor
5

Startup

5.1

Starting up the system

Uncontrolled system movement
When starting up, if the sensor is part of a closed loop
system whose parameters have not yet been set, the
system may perform uncontrolled movements. This
could result in personal injury and equipment damage.
► Persons must keep away from the system's
hazardous zones.
► Startup must be performed only by trained technical
personnel.
► Observe the safety instructions of the equipment or
system manufacturer.
1. Check connections for tightness and correct polarity.
Replace damaged connections.
2. Check BCM for tight attachment.
3. Turn on the system.
4. Check measured values and adjustable parameters
and readjust the BCM if necessary.
Check for the correct values, especially after
replacing the BCM or after repair by the
manufacturer.
The BCM must be individually configured in
most cases. The description in this user's guide
can be used to aid in configuration. Assigning of
parameters requires a basic understanding of
the variables to be measured.
A BCM can be replaced easily and without loss of the
configuration parameters by using the IO-Link function
Data Storage or the parameter server.
5.2

Operating notes

– Regularly check function of the BCM and all associated
components.
– Take the BCM out of service whenever there is a
malfunction.
– Secure the system against unauthorized use.
– Check fasteners and retighten if needed.
– When installing using a magnetic holder, bear in mind
that vibration may affect proper fit. Regularly check for
proper holding and correct alignment when using this
installation method.
18 english
DANGER