Electrical Connection - Balluff BOS R254K-UUI-LH10-S4 Montageanleitung

BOS R254K-UUI-LH10-S4
Photoelectric Sensors
Dimensions and function
BOS R254K-...-LH11/LK10/LE10/LS10-...
20.4
17.8
A2
A1
M12x1

Electrical connection

Pin Signal
1 L+ (Operating voltage +,
SIO 10...30 V, IO-Link 18...30 V)
...-LH10-...
2
I/Q (Digital input / digital output /
analog output)
...-LH11/LK10/LE10/LS10-...
I/Q (digital input / digital output)
3 L− (Operating voltage −)
4 C/Q (IO-Link communication /
digital output in SIO mode)
Factory setting
– Mode: SIO mode
– Object recognition operating mode: Standard
– PIN 2: Switching output (push-pull)
– PIN 4: Switching output (push-pull)
Also see document IO-Link configuration under
www.balluff.com on the product page.
Cable length
For IO-Link operation, the maximum cable length is 20 m.
www.balluff.com
49.5
4.3
9.8
LED 2 LED 1
1
2 4
3
Plug layout
(top view of
M12 plug on
BOS)
BOS R254K-...-LH10-...
20.4
17.8
4.3
A2
A1
M12x1
Plug outlet direction (Example image of use with angled
connector (accessory))
Type A1
LH10 Optical axis of
Optical axis of
emitter receiver
LH11
LK10 Optical axis of
LS10 emitter and
receiver
LE10
BOS R254K-...-LH10/LH11-...
In the case of a diffuse sensor with adjustable background
suppression, the emitted light is reflected by the object and
evaluated in the receiver. The background suppression
allows recognition in the detection range that is almost
object-independent.
BOS R254K-...-LK10-...
In the case of a retroreflective sensor, the emitted light is
reflected back to the sensor by a reflector. Interruption of
the light beam by an object causes the switching
operation.
BOS R254K-...-LE10/LS10-...
Through-beam sensors are sensors having separate
transmitter and receiver units which must be aligned with
each other on opposite ends of the detection range. When
an object interrupts the light beam, the receiver switches,
i.e. the output signal changes.
49.5
9.8
LED 2 LED 1
A2 X1 X2
9.3 16.6
15.3 11
32.1
– –
30.3
english 2