Heidolph Hei-VAP Precision Originalbetriebsanleitung Seite 61

Flask depth
A stop bolt is located on the right side of the lift pillar with which you can adjust a
constant depth for the evaporating flask.
✓ Rotation is set to 0 rpm.
✓ Evaporating flask is mounted (see
chapter "Operation", section "Mount
evaporating flask").
✓ Height stop is at top position.
Adjust height without guard hood:
➜ Move down lift until it has reached the
desired depth
(see chapter "Start-Up, Heating bath
and lift").
➜ Turn fixing screw on stop bolt of lift
pillar approx. 180° counter clockwise.
➜ Slide stop bolt via fixing screw
downwards as far as it will go.
➜ Fasten fixing screw clockwise.
➜ Move the lift upwards.
✓ The fixing screw allows to individually
adjust the lowest flask position.
✓ The lift cannot be lowered beyond this
point.
Adjust height with guard hood:
➜ Hold guard hood with one hand.
➜ Move guard hood manually when
adjusting the lift.
Downloaded from www.Manualslib.com
Assembly
manuals search engine
Fixing screw
Lift contact
61
Stop bolt