Heating Bath; Vapor Tube - Heidolph Hei-VAP Precision Originalbetriebsanleitung

Heating bath

Attach heating bath
✓ A movable base plate with an
enhanced guide rail is located on the
right side of the base unit.
➜ Place heating bath with gap on the
guide rail.
➜ Move heating bath carefully to the left
and right to lock it.
Move heating bath
It may be necessary to increase the distance between heating bath and drive when
bigger evaporating flasks or spacers between the evaporating flask and vapor tube are
used.
✓ Base unit is placed on a stable surface.
➜ Allow sufficient space to move heating bath.
✓ On the right side the heating bath slides out approximately 20 cm to allow for
adjustment.
➜ Hold heating bath on both handles and slide it to the right until you have reached the
desired position.

Vapor tube

Assembly parts
▪ Vapor tube
▪ Flask clamp Easy-Clip
▪ Coupling vapor tube
▪ Clamping sleeve
The flask clamp Easy-Clip is
pre-assembled in NS 29. For smaller flasks
the Easy-Clip NS 24 is enclosed.
The device is delivered with
pre-assembled coupling for the vapor tube
and the condenser.
➜ Hold the locking knob beneath "lock"
for a quarter turn.
➜ Unscrew the coupling of the vapor tube
along with the vapor tube on the right
side of the drive.
➜ Unscrew the coupling of the condenser
on the left side of the drive.
Downloaded from www.Manualslib.com
Assembly
manuals search engine
Base plate
Guide rail
Coupling vapor tube
Clamping sleeve
Motor drive
Coupling
condenser
Lock
vapor tube
52
Heating bath
Recess
Vapor tube
Flask clamp Easy-Clip
Flask clamp
Easy-Clip
Vapor tube
coupling