Vapor Temperature Sensor, Autoaccurate Sensor; Evaporating Flask Angle And Depth - Heidolph Hei-VAP Precision Originalbetriebsanleitung

Vapor temperature sensor, AUTOaccurate sensor

Vapor temperature sensor
(Optional accessory)
AUTOaccurate sensor
(Glassware set G3 and G6 only)
Opening for vapor temperature sensor
and AUTOaccurate sensor is located at the
bottom of the condenser.
➜ Remove sealing cap of condenser.
➜ Insert vapor temperature sensor into
condenser.
➜ Tighten vapor temperature sensor with
screw cap.
➜ Plug in connector plug with white mark
upwards into receptacle on the left
side of unit.

Evaporating flask angle and depth

Evaporating flask angle
Evaporating flask angle can be adjusted by turning the drive.
✓ Rotation is set to 0 rpm.
✓ Evaporating flask is mounted (see chapter "Operation", section "Mount evaporating
flask").
➜ Hold condenser with your left hand.
➜ Slide locking mechanism on lift pillar to
the right and hold it against the spring
force.
➜ Move condenser carefully until
connected evaporating flask has the
correct angle.
➜ Release locking mechanism.
➜ If necessary move condenser slightly
until it locks in.
Downloaded from www.Manualslib.com
Assembly
manuals search engine
Opening vapor temperature sensor
Connector plug vapor temperature sensor
Screw cap vapor temperature sensor
Locking
60
Lift pillar