Herunterladen Inhalt Inhalt Diese Seite drucken

Inlet Tubes - Heidolph Hei-VAP Precision Originalbetriebsanleitung

Rotationsverdampfer
Vorschau ausblenden Andere Handbücher für Hei-VAP Precision:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Inlet tubes

Assembly parts:
▪ 2x Inlet tube
▪ 1x Inlet valve
On the bottom left side of the condenser a ground opening is located to include stopcock
with inlet tube.
Inlet tube 1
➜ Shorten supplied PTFE tube so that
the end of the tube leads to the
evaporating flask and attach it to the
stopcock.
➜ Slide drain disk onto PTFE tube so that
it is placed below the vapor opening of
condenser.
✓ Condensed fluid cannot flow back into
evaporating flask through inlet tube.
➜ Unscrew screw cap from condenser.
➜ Slide seal ring and screw cap approx.
3 cm onto PTFE tube.
➜ Insert PTFE tube with seal ahead into
inlet opening and tighten screw cap.
Inlet tube 2
➜ Unscrew the screw cap including the
seal ring of inlet opening.
➜ Slide seal ring and screw cap approx.
3 cm onto PTFE tube.
➜ Insert PTFE tube with seal ahead into
inlet opening and tighten screw cap.
✓ Inlet tubes are mounted.
Inlet tubes glassware set G1
Openings for inlet tubes are located on the
top of the condenser.
Downloaded from
www.Manualslib.com
Assembly
manuals search engine
Inlet valve
Screw cap
Ventilation cap
Inlet valve
Inlet tube 2
G1: Screw cap inlet tube 1
59
Drain disk
Vapor tube
Inlet tube 1
Screw cap
Inlet tube 2
Screw cap inlet tube 2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis