Connecting Peripheral Devices; Connect Cooling Water; Mount Tubes - Heidolph Hei-VAP Precision Originalbetriebsanleitung

Connecting peripheral devices



Connect cooling water

Assembly parts:
▪ 2x tube nipples
(included in scope of delivery)
▪ 1x tube, inner Ø 7-8mm
(not included in scope of delivery)
Input and output for cooling water is
located on the back of condenser.
➜ Remove screw cap from input and
output of the cooling water.
➜ Push screw cap over tube nipples so
that the black seal is placed inside the
cap.
➜ Push intake and outflow hoses for
cooling water through screw cap over
one of each tube nipple.
➜ Tighten screw cap with seal side up to
the openings of condenser.
✓ Intake and outflow of cooling water are
connected.

Mount tubes

To mount tubes a tubing clamp is located
on the back of device.
Downloaded from www.Manualslib.com
Assembly
manuals search engine
Tube nipples
Input and output cooling water
63
Tubing clamp