Bedienung
Abb. 62
Entfernen eines Schubeinsatzes:
•
Modul leicht anheben und herausziehen
•
Modul an den Seitenteilen ganz herausheben
•
Modulgriff abnehmen
Das Modul darf nicht am
Modulgriff getragen werden
4.4 Sicherungslasttrennschalter SR
Der NH-Sicherungslasttrennschalter Typ SR ist ein dreipoliges
Kombigerät mit den Schaltfunktionen >>Lastschalten<< und
>>Sichern<<. Das Lastschaltelement ist mit Sprungantrieb
ausgerüstet.
Der Kipphebel ist vor dem Bedienen nach links auszuschwenken
und zu verrasten. Zum Einschalten ist der Griff um 45° zur Seite zu
drücken. Er ist in Aus-Stellung mit bis zu drei Vorhängeschlössern
abschließbar.
Die ElN-Position des Schalters ist mit 1 (rot) angezeigt. Die AUS-
Position des Schalters ist mit 0 (grün) angezeigt. Ausgelöste
Sicherungen sind durch den transparenten Deckel von außen
erkennbar.
Eine Verriegelung verhindert das Öffnen der Frontabdeckung im
Einschaltzustand.
Bei Anwendung der SR-M-Leiste als Einspeisung sind die
Sicherungen bei ausgeschaltetem SchaIter spannungsfrei.
MNS Service
Operation
Fig. 62
Removal of a railable module:
•
Lift module slightly and pull it out
•
Lift module out totally by grabbing it on its sides
•
Remove service handle
The module must not be carried
by its service handle
4.4 Fused Ioad-break switch type SR
The LV HRC fused load-break switch type SR is a three pole
multi function device covering the switch functions >>load-
breaking<< and >>protecting (fuses)<<. The loadbreak switch is
provided with a spring assisted mechanism.
The toggle must be pulled to the left and latched before
operating. For switching on, the handle has to be pushed to the
side for 45°. The handle can be locked in the OFF-position with
up to three padlocks.
The ON-position of the switch is marked 1 (red). The OFF-
position of the switch is marked 0 (green). Whether or not fuses
are blown can be observed easily since the cover is of
transparent material.
An interlock prevents the front-cover from being opened in case
the switch is in ON-position.
When using the SR-M fused load break switch as incoming
feeder it must be noted that the fuses are de-energized in the
OFF-position of the switch.
4
53