Herunterladen Inhalt Inhalt Diese Seite drucken

Fetten Von Kontaktflächen; Fetten Der Leistungskontakte; Greasing Of Contact Areas - ABB MNS Servicehandbuch

Low voltage switchgear
Vorschau ausblenden Andere Handbücher für MNS:
Inhaltsverzeichnis

Werbung

Wartung und Ersatzteile
5.6 Fetten von Kontaktflächen

5.6.1 Fetten der Leistungskontakte

Das Fetten der Kontakte ist eine unabdingbare Voraussetzung für die
einwandfreie Funktion des Kontakts, da es die Abnutzung der Kon-
taktflächen-Veredelung reduziert. Außerdem werden die Einschub-
kräfte verringert.
Die Kontaktflächen der Leistungskontakte sind zu reinigen und zu
fetten, wenn folgende Bedingungen zutreffen:
nach Abschluss der Montage- und Prüfarbeiten in der Werkstatt
nach einer Revision bzw. spätestens nach 100 Steckzyklen oder
nach Ablauf von 2 Jahren.
Dies hat jeweils unmittelbar vor dem Einsetzen des Moduls in das
Feld zu erfolgen.
Zu verwendendes Fett: Kontaktfett Klüberlectric KR44-102
Zum Auftragen des Fettes ist ein Pinsel zu verwenden.
Eine Überfettung der Kontakte ist zu vermeiden.
Wenn die Module lose geliefert werden, werden die Module erst
auf der Baustelle gefettet.
Zu fettende Kontaktflächen siehe Abbildungen 89 und 90
Abb. 89 / Fig. 89
Leistungskontakte für Einschübe Größe 8E/4 und 8E/2,
sowie abgangsseitige Leistungskontakte des 4E-Einschubes
Power contacts for withdrawable modules size 8E/4 and 8E/2
as well as the outgoing power contacts of the 4E-withdrawable
modules
Kontakte des Einschubkondapters sowie der SR-Leisten sind ähnlich
zu behandeln.
76
zu fettende Flächen
areas to be greased
Maintenance
and Spare Parts

5.6 Greasing of contact areas

5.6.1 Greasing of power contacts
Greasing the contacts is a mandatory prerequisite for reaching the
operating cycles to which the unit is certified through type test as
the grease reduces the wear of the contact area finish. Further-
more, the force needed for withdrawing the modules is reduced.
Contact areas of the power contacts are to be cleaned and
greased whenever the following conditions apply:
the assembly works and testing routines have been completed
in the workshop
after a revision or after 100 plug-in cycles or after 2 years,
whichever is earlier
immediately before installing the module in the cubicle.
Grease to be applied:
Contact grease Klüberlectric KR44-102
Use a brush to apply the grease.
Avoid excess grease on the contacts.
If modules are supplied as loose parts, they should be greased
at the building site.
For contact areas to be greased, see figures 89 and 90
Abb. 90 / Fig. 90
Leistungskontakte für Einschübe Größe 4E bis 48E
Power contacts for withdrawable modules size 4E to 48E
Contacts of the withdrawable module condapter as well as of SR
switch disconnectors are to be treated similarily.
5
zu fettende Flächen
areas to be greased
MNS Service

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis