Printing Format For Tightening Results; Pc2 Format; Pc3 Format - Desoutter CVIC II Bedienungsanleitung

6159932190
Issue no: 02
8 - PRINTINg FORMAT FOR
TIghTENINg RESuLTS

8.1 - PC2 format

Char
Designation
number
1 char. <CR>
2 range or cycle number
2 fastener number
3 "T=+"
5 torque in 1/10 of Nm
1 <LF>
1 " "
1 <CR>
2 range or cycle number
2 fastener number
3 "A=+"
5 angle in 1/10 of degree
1 <LF>
1 " "
1 <CR>
2 range or cycle number
2 fastener number
3
5
1 <LF>
1 " "
Example of result:
<CR>0109T=+00400<LF> <CR>0109A=+01200<LF>
<CR>0109TR=+00580<LF>
The last result in the list ends with <LF><LF> instead of
<LF>""
46 / 62
Original instructions

8.2 - PC3 format

Char
Designation
number
1 char. A (frame type)
3 station number (1 to 250)
3 port number (1 to 32)
configuration (A to O correspond to
1
configurations 1 to 15)
1 Z (system identifier)
1 char. A (frame type)
1
report code (see chart below)
6 date (year, month, day)
6 time (hour, minute, second)
8 torque
5 angle
1 <CR>
Checksum (modulo sum 256 of the previous
1
characters) not calculated for the moment
1 <LF>
The last result in the list ends with <LF><LF> instead of
<LF>
Report code: ASCII code 0100 :
1 2
X X X
Legend
1 1 = max. angle
2 1 = min. angle
3 1 = max. torque
4 1 = min. torque
According to the various combinations, the following
characters will be obtained:
@
accept torque
A min. torque
B max. torque
D accept torque
E min. torque
F max. torque
h accept torque
I min. torque
J max. torque
on servodrive fault
or spindle belonging to reject group
0x00 or cycle start drop
or cycle not completed for spindle
or transducer fault
Example of result:
A001001BZ@92120811021500041.7500121<CR>
<CS><LF>
CVIC II
3 4
X
accept angle
accept angle
accept angle
min. angle
min. angle
min. angle
max. angle
max. angle
max. angle
04/2010