Channel Test Menu; Counters Menu - Desoutter CVIC II Bedienungsanleitung

6159932190
Issue no: 02
6.1.1.3 - LEDS TEST menu
This menu allows for testing the LEDs located on the
front side of the CVIC and for testing the LEDs on the
tool.

6.1.2 - ChANNEL TEST menu

This menu is used to test the operation of the controller
and tool. There is a sequence of two tests:
● Reading the information contained in the tool memory
● Checking the servo drive board.
If an error arises, a message is displayed.
Press to display an additional error
message.
40 / 62
Original instructions

6.1.3 - COuNTERS menu

This menu allows the maintenance technician to know
the number of cycles run.
● The Controller counter shows the number of cycles
run since delivery.
● The Tot. (total) and Par. (partial) counters show the
number of cycles run by the tool.
● Select Reset to reset the partial counter of the tool.
CVIC II
04/2010