Input Menu - Desoutter CVIC II Bedienungsanleitung

CVIC II

5.6.3 - INPuT menu

Inputs Name
Cycle 1 selection CyC1
Cycle 2 selection CyC2
Cycle 4 selection CyC4
Cycle 8 selection CyC8
Spindle validation SPVAL
Tightening SPVALFS
direction
validation
Run reverse SPVALRV
direction
validation
Error ACKNOW
acknowledgement
Start cycle SCy
Tightening / Run DIR
reverse
Reset RESET
External stop EXSTOP
Synchronization SyNC
04/2010
Original instructions
Factory Comments
config.
X Binary coding - weight 1, i.e. from 0 to 15
X Binary coding - weight 2, i.e. from 0 to 15
X Binary coding - weight 4, i.e. from 0 to 15
X Binary coding - weight 8, i.e. from 0 to 15
X Validates - or not - the tool start in both tightening directions if "Sp. val."
is enabled in the Station Menu.
Validates - or not - the tool start in the tightening direction if"Sp. val." is
enabled in the Station Menu.
Validates - or not - the tool start in the run reverse direction if "SpV.rrv" is
enabled in the Station Menu.
No effect in ECPHT mode.
X Validates again the tool operation after a reject report if the error
acknowledgement function in the Station Menu is enabled.
X
The cycle is run as long as the signal is at 1.
When the signal drops, the cycle stops and the report is sent to the PLC.
X Validates the un-tightening direction as soon as the Start Cycle signal appears,
at the speed programmed in the Station Menu and with the maximum current of
the tool.
X This signal resets the tightening reports and deletes the results
displayed.
When the parameter is programmed on Yes in the programming screen
of the run down speed, final speed and run reverse phases, the system
stops the current phase on a pulse and switches to the next one.
Validates the synchronization of the tightening phases of several
controllers (see "Synchronizing several cvic controllers", page 44).
6159932190
Issue no: 02
29 / 62