Output Menu - Desoutter CVIC II Bedienungsanleitung

CVIC II

5.6.4 - OuTPuT menu

Outputs Name
Cycle 1 CyC1
acknowledgement
Cycle 2 CyC2
acknowledgement
Cycle 4 CyC4
acknowledgement
Cycle 8 CyC8
acknowledgement
Ready READy
In cycle INCyC
global report OK ACCRP
global report NOK REJRP
Number of cycles NCyOK
OK
Synchronization SyNC
Torque report OK TOROK
Torque report NOK TORNOK
Angle report OK ANgOK
Angle report NOK ANgNOK
04/2010
Original instructions
Factory Comments
config.
X Binary coding -weight 1. The cycle acknowledgement is sent back only if
it corresponds to a programmed cycle; otherwise it is at "0".
X Binary coding -weight 2. The cycle acknowledgement is sent back only if
it corresponds to a programmed cycle; otherwise it is at "0".
X
Binary coding -weight 4. The cycle acknowledgement is sent back only if
it corresponds to a programmed cycle; otherwise it is at "0".
X Binary coding -weight 8. The cycle acknowledgement is sent back only if
it corresponds to a programmed cycle; otherwise it is at "0".
X This signal is at "1" when the controller is in working order.
X Response to the Start Cycle request. Drops to "0" at end of cycle.
X Sent to the PLC when the cycle is over and the global report is OK.
X Sent to the PLC when the cycle is over and the global report is NOK.
X This signal switches to "1" when the number of cycles run with an Accept
report is equal to the programmed number of cycles OK.
The synchronization signal falls down at the end of the phase and is
used, connected with synchronization of other controllers to synchronize
the next phase (see "Synchronizing several cvic controllers", page 44).
Sent to the PLC when the cycle is over and the torque report is OK.
Sent to the PLC when the cycle is over and the torque report is NOK.
Sent to the PLC when the cycle is over and the angle report is OK.
Sent to the PLC when the cycle is over and the angle report is NOK.
6159932190
Issue no: 02
31 / 62