Programming The Phase - Desoutter CVIC II Bedienungsanleitung

6159932190
Issue no: 02
Except for the approach phase, this action on NOK is
performed only if an inter-phase time is programmed.
Warning: when used with hand held tools,
programming an action on NOK with run
reverse may be dangerous for the operator.
Select the relevant action:
Parameter Comment
unused The option is disabled.
Stop cycle As soon as one of the torque or angle
parameters is out of tolerances at the
end of one of the phases, the cycle
stops at the end of this phase.
Run reverse The cycle stops under the same
circumstances as in the Stop Cycle
option, then the tool un-tightens with the
programmed number of rotations.
N.rotat Number of run reverse rotations
performed by the tool in case of fault
(0-100).
The value 0 causes a run reverse
action which is equal to the number of
rotations performed in the approach
phase if this phase has been
programmed.
Otherwise, the number of rotations is
equal to 0.
Rv speed Run reverse speed associated with an
action on NOK per cycle or per phase.
Thread
Right / Left.
When an action on NOK phase has been
programmed, it will be processed as a priority
with respect to the action on NOK of the cycle.
18 / 62
Original instructions

5.3.4 - Programming the phase

After selecting a cycle, the cursor will move to the line
where the various phases of the selected cycle are
shown. You will be allowed to modify, insert or delete a
phase.
5.3.4.1 - Creating (or changing) a phase
CVIC II
04/2010