Mitsubishi Electric PUMY-P100VHMB Installationshandbuch Seite 12

 7HVW UXQ
 %HIRUH WHVW UXQ
$IWHU FRPSOHWLQJ LQVWDOODWLRQ DQG WKH ZLULQJ DQG SLSLQJ RI WKH LQGRRU DQG
RXWGRRU XQLWV FKHFN IRU UHIULJHUDQW OHDNDJH ORRVHQHVV LQ WKH SRZHU VXSSO\
RU FRQWURO ZLULQJ ZURQJ SRODULW\ DQG QR GLVFRQQHFWLRQ RI RQH SKDVH LQ WKH
VXSSO\
8VH D YROW 0RKP WHVWHU WR FKHFN WKDW WKH UHVLVWDQFH EHWZHHQ WKH SRZHU
VXSSO\ WHUPLQDOV DQG JURXQG LV DW OHDVW  0Ÿ
'R QRW FDUU\ RXW WKLV WHVW RQ WKH FRQWURO ZLULQJ ORZ YROWDJH FLUFXLW WHUPLQDOV
Warning:
'R QRW XVH WKH DLU FRQGLWLRQHU LI WKH LQVXODWLRQ UHVLVWDQFH LV OHVV WKDQ  0Ÿ
,QVXODWLRQ UHVLVWDQFH
After installation or after the power source to the unit has been cut for an extended
SHULRG WKH LQVXODWLRQ UHVLVWDQFH ZLOO GURS EHORZ  0Ÿ GXH WR UHIULJHUDQW DFFXPXODW-
ing in the compressor. This is not a malfunction. Perform the following procedures.
1. Remove the wires from the compressor and measure the insulation resistance of
the compressor.
 ,I WKH LQVXODWLRQ UHVLVWDQFH LV EHORZ  0Ÿ WKH FRPSUHVVRU LV IDXOW\ RU WKH UHVLVWDQFH
dropped due the accumulation of refrigerant in the compressor.
 7HVW UXQ
 8VLQJ UHPRWH FRQWUROOHU
Refer to the indoor unit installation manual.
‡ %H VXUH WR SHUIRUP WKH WHVW UXQ IRU HDFK LQGRRU XQLW 0DNH VXUH HDFK LQGRRU XQLW
operates properly following the installation manual attached to the unit.
‡ ,I \RX SHUIRUP WKH WHVW UXQ IRU DOO LQGRRU XQLWV DW RQFH \RX FDQQRW GHWHFW DQ\
erroneous connection, if any, of the refrigerant pipes and the connecting wires.
* The compressor operation is not available for 3 minutes at least after the power
is supplied.
‡ 7KH FRPSUHVVRU FDQ HPLW QRLVH MXVW DIWHU WXUQ RQ WKH SRZHU VXSSO\ RU LQ FDVH
of low outside air temperature.
$ERXW WKH UHVWDUW SURWHFWLYH PHFKDQLVP
Once the compressor stops, the restart preventive device operates so the compressor
will not operate for 3 minutes to protect the air conditioner.
 5HIULJHUDQW FROOHFWLQJ 3XPS GRZQ
Perform the following procedures to collect the refrigerant when moving the indoor
unit or the outdoor unit.
1 Turn off the circuit breaker.
2 Connect the low pressure side of the gauge manifold to the service port of the
gas side stop valve.
3 Close the liquid stop valve.
4 Supply power (circuit breaker).
* Start-up of the indoor-outdoor communication takes about 3 minutes after the
power (circuit breaker) is turned on. Start the pump-down operation 3 to 4 minutes
DIWHU WKH SRZHU FLUFXLW EUHDNHU LV WXUQHG 21
5 &RQ¿UP WKDW 6: LV VHW WR 2)) DQG WKHQ VHW 6: WR 21 WR SHUIRUP WKH WHVW
run for cooling operation. The compressor (outdoor unit) and ventilators (indoor
and outdoor units) start operating and test run for cooling operation begins.
Immediately after performing the test run for cooling operation, set the outdoor
VHUYLFH VZLWFK 6: SXPS GRZQ VZLWFK IURP 2)) WR 21
'R QRW FRQWLQXH WR RSHUDWH IRU D ORQJ WLPH ZLWK WKH VZLWFK 6: VHW WR 21 0DNH
sure to switch it to OFF after pump down is completed.

3. After connecting the wires to the compressor, the compressor will start to warm
up after power is supplied. After supplying power for the times indicated below,
measure the insulation resistance again.
‡ 7KH LQVXODWLRQ UHVLVWDQFH GURSV GXH WR DFFXPXODWLRQ RI UHIULJHUDQW LQ WKH FRP-
SUHVVRU 7KH UHVLVWDQFH ZLOO ULVH DERYH  0Ÿ DIWHU WKH FRPSUHVVRU LV ZDUPHG
up for four hours.
(The time necessary to warm up the compressor varies according to atmospheric
conditions and refrigerant accumulation.)
‡ 7R RSHUDWH WKH FRPSUHVVRU ZLWK UHIULJHUDQW DFFXPXODWHG LQ WKH FRPSUHVVRU WKH
compressor must be warmed up at least 12 hours to prevent breakdown.
 ,I WKH LQVXODWLRQ UHVLVWDQFH ULVHV DERYH  0Ÿ WKH FRPSUHVVRU LV QRW IDXOW\
&DXWLRQ
‡ 7KH FRPSUHVVRU ZLOO QRW RSHUDWH XQOHVV WKH SRZHU VXSSO\ SKDVH FRQQHFWLRQ
LV FRUUHFW
‡ 7XUQ RQ WKH SRZHU DW OHDVW  KRXUV EHIRUH VWDUWLQJ RSHUDWLRQ
- Starting operation immediately after turning on the main power switch can result
in severe damage to internal parts. Keep the power switch turned on during the
operational season.
7KH IROORZLQJV PXVW EH FKHFNHG DV ZHOO
‡ 7KH RXWGRRU XQLW LV QRW IDXOW\ /(' RQ WKH FRQWURO ERDUG RI WKH RXWGRRU XQLW ÀDVK
when the outdoor unit is faulty.
‡ %RWK WKH JDV DQG OLTXLG VWRS YDOYHV DUH FRPSOHWHO\ RSHQ
 8VLQJ 6: LQ RXWGRRU XQLW
1RWH
,Q FDVH RI WKH WHVW UXQ IURP RXWGRRU XQLW DOO LQGRRU XQLWV RSHUDWH 7KHUHIRUH
\RX FDQ QRW GHWHFW DQ\ HUURQHRXV FRQQHFWLRQ RI UHIULJHUDQW SLSHV DQG WKH
FRQQHFWLQJ ZLUHV ,I LW DLPV DW GHWHFWLRQ RI DQ\ HUURQHRXV FRQQHFWLRQ EH VXUH
WR FDUU\ RXW WKH WHVW UXQ IURP UHPRWH FRQWUROOHU ZLWK UHIHUHQFH WR ³ 8VLQJ
UHPRWH FRQWUROOHU´
6: 21
6: OFF
6: 21
6: 21
$IWHU SHUIRUPLQJ WKH WHVW UXQ VHW 6: WR 2))
‡ $ IHZ VHFRQGV DIWHU WKH FRPSUHVVRU VWDUWV D FODQJLQJ QRLVH PD\ EH KHDUG IURP
the inside of the outdoor unit. The noise is coming from the check valve due to the
small difference in pressure in the pipes. The unit is not faulty.
7KH WHVW UXQ RSHUDWLRQ PRGH FDQQRW EH FKDQJHG E\ ',3 VZLWFK 6: GXULQJ
WKH WHVW UXQ 7R FKDQJH WKH WHVW UXQ RSHUDWLRQ PRGH GXULQJ WKH WHVW UXQ VWRS
WKH WHVW UXQ E\ ',3 VZLWFK 6: $IWHU FKDQJLQJ WKH WHVW UXQ RSHUDWLRQ PRGH
UHVXPH WKH WHVW UXQ E\ VZLWFK 6:
6 Fully close the gas stop valve when the pressure reading on the gauge drops
0.05 - 0.00 MPa (approximately 0.5 - 0.0 kgf/cm
7 6HW 6: WR 2)) WR VWRS WKH DLU FRQGLWLRQHU RSHUDWLRQ 6HW WKH RXWGRRU VHUYLFH
VZLWFK 6: IURP 21 WR 2))
8 Turn off the power supply (circuit breaker).
* If too much refrigerant has been added to the air conditioner system, the pressure
may not drop to 0.5 kgf/cm 2 . If this occurs, use a refrigerant collecting device
to collect all of the refrigerant in the system, and then recharge the system with
the correct amount of refrigerant after the indoor and outdoor units have been
relocated.
Warning:
:KHQ SXPSLQJ GRZQ WKH UHIULJHUDQW VWRS WKH FRPSUHVVRU EHIRUH GLVFRQQHFW-
LQJ WKH UHIULJHUDQW SLSHV 7KH FRPSUHVVRU PD\ EXUVW DQG FDXVH LQMXU\ LI DQ\
IRUHLJQ VXEVWDQFH VXFK DV DLU HQWHUV WKH V\VWHP
Cooling operation
Heating operation
2
)