Managing Prostheses - Ottobock C-Leg 3C98-3 Gebrauchsanweisung

Remote control app
Once the connection has been established, the data are read from the prosthesis. This process may take a few
seconds. After adding/deleting a component, the main menu appears with the names of the connected prostheses.

9.5.1 Managing prostheses

Connections with up to four different components can be stored in the app. However, a component can only be
connected to one device or remote control at a time.
Adding component
1) If components have already been added, tap the symbol (extended menu) in the main menu.
2) Then tap the option "Manage components".
3) In the following screen, tap the "Add component" button.
→ The "Preparation" screen appears. The serial number of the component should be entered here. The serial
number begins with the letters "SN".
4) Follow the subsequent instructions on the screen.
5) After the PIN code is entered, a connection to the prosthesis is established.
→ While the connection is being established, 3 beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the prosthesis. This process may take
up to a minute.
The main menu will then appear with the name of the connected prosthesis.
Deleting a component
1) Tap the symbol (extended menu) in the main menu.
2) Then tap the option "Manage components".
3) Tap the symbol under the component you want to delete.
→ The component is deleted.
Connecting component with multiple devices
A component can be connected to multiple devices (see Page 76).
If there is an existing connection between the component and a different device, the following information appears
while the connection is being established:
78 | Ottobock
symbol appears.
C-Leg 3C98-3/3C88-3