[Setting - Language] Screen; [Setting - Receipt] Screen - Sony UPA-PC105 Benutzerhandbücher

[Setting - Language] Screen

Touch the [Language] tab to open the [Setting -
Language] screen and select the display language for
system operation.
You can select up to three of the languages displayed.
On the operation screen touch a language button to
select it. If you select more than one language, language
buttons are displayed for you to select every time the
system starts up.
Note
The screen can display up to seven languages at one
time. If you do not see the language that you want to
select, touch the [more] button to go to the next screen
and display more languages.
SETTING END
• Touch the [OK] button to temporarily save the settings
that you made. To confirm the settings, touch the [OK]
button repeatedly until the screen prompting you to
confirm whether you want to save the settings appears,
then touch the [OK] button to close the configuration
screen.
• Touch the [Cancel] button to ignore the modifications
that you made and restore the previous settings. If you
touch this button on the screen that appears
immediately after you touch one of the tabs, all the
settings that you have made on that tab are ignored,
and the screen returns to the password entry screen.
56
GB
Settings

[Setting - Receipt] Screen

Touch the [Receipt] button to open the [Setting -
Receipt] screen that presents the settings for printing
receipts.
[ON/OFF] button
When this setting is [ON], a receipt is printed after every
output service operation is completed. Touch this button
to toggle the setting [ON] (enable print) or [OFF]
(disable print).
[Auto] button
If this setting is [ON], a receipt is automatically printed
when image data output is complete. Touch this button
to toggle the setting [ON] (receipt automatically output)
or [OFF] (receipt not automatically output).
[InstallLogo] button
You can change the logo printed on receipts to match
your shop logo.
The image (8-bit grayscale or binary black and white)
that you want to use for the logo must be 300 × 150
(W × H) pixels, and saved on a floppy disk in bitmap file
format under the file name "logo_bw.bmp".
Touch the [InstallLogo] button to display the screen
where you can change the logo. Follow the on-screen
instructions to complete the procedure.