Sony UPA-PC105 Benutzerhandbücher Seite 59

Notes
• You can use the following file formats for the
screensavers: .bmp for still images, .avi or .mpg
(MPEG-1 format only) file formats for movies.
• Up to four files can be selected for the initial
screensaver and the print screensaver.
• Still image files used by screensavers should be
1024 × 768 pixels, while movie files should be
1024 × 768 pixels or less. The file names should be
[Startup1.*] to [Startup4.*] for the initial screen
screensaver and [Printing1.*] to [Printing4.*] for the
printing screen screensaver (where the asterisk (*)
represents the .bmp, .avi, or .mpg file extension). They
should be saved in the root directory of a "Memory
Stick" or CD-R. The files can be installed from the
"Memory Stick" or CD-R.
• [Start up] button
Used to make the initial screen screensaver settings.
Touch the [Start up] button to display settings screen.
– [Startup1] to [Startup4]
Touching the buttons switches the file display [ON]
or [OFF].
After the interval set in [Time(sec)] elapses when
the initial screen is displayed, the selected still
images or movies (set to [ON]) are displayed on the
screen. [Startup1] to [Startup4] correspond to the
files installed as [Startup1.*] to [Startup4.*].
– [Time(sec)] button
Time interval before the screensaver is displayed.
Touch this button to display the time input (seconds)
screen. The interval must be between 1 and 600
seconds.
• [Printing] button
Used to make the settings for the functioning of the
screensaver display during printing. Touch the
[Printing] button to display the setting screen.
– [Printing1] to [Printing4]
Touching the buttons switches the file display [ON]
or [OFF].
After the interval set in [Time(sec)] elapses when
the printing screen is displayed, the selected still
images (set to [ON]) are displayed on the screen.
[Printing1] to [Printing4] correspond to the files
installed as [Printing1.*] to [Printing4.*]
– [Time(sec)] button
Time interval before the screensaver is displayed.
Touch this button to display the time input (seconds)
screen. The interval must be between 1 and 600
seconds.
• [Interval] button
Time interval during which the still pictures are
displayed (when more than one file is selected as the
screensaver). Touch this button to display the time
input (seconds) screen. The interval must be between
1 and 600 seconds.
Notes
• If only one still image is selected as the screensaver,
it is displayed continuously.
• If a movie is selected as the screensaver, the movie
plays to its end, regardless of the [Interval] button
setting.
• [Install] button
Touch this button to display the screen where still
images or movies are added. Follow the instructions
on the screen to perform the operation.
[Caution] button
Touch this button to open the [Setting - Other - Caution]
screen to make the warning display settings for each
output service.
59
GB
Settings