Sony UPA-PC105 Benutzerhandbücher Seite 9

2 When you are prompted to, remove the media,
then touch the [OK] button in the lower-right
corner of the screen.
You are prompted to insert a different storage
media.
3 Follow the instructions outlined from Step 2 of
"Inserting the Media" (page 7) to Step 2 of
"Selecting the Images and Specifying the
Number of Copies to Print" (page 8).
4 Depending on the number of times that you
want to change media, repeat Steps 1 to 3 as
many times as necessary.
4
When you are done specifying the number of copies
to print, touch the [OK] button in the lower-right
corner of the screen.
Data is read from the storage media.
5
When the message prompts you to remove that
media after reading is completed, remove the
media, and then touch the [OK] button in the lower-
right corner of the screen.
A screen appears, allowing you to confirm the price
of the print job.
Confirming Prices, Entering Passwords
To print, you must enter a password. The default
password is "1111". At this point, you can also save your
operations up-to-date, use a different output service, and
perform all the output operations simultaneously when
you are done.
Note
You can use the configuration screen to determine
whether a password must be entered before printing and
to change passwords.
For details, see "[Setting - Other] Screen" (page 58).
1
Confirm the prices, and then touch the [Confirm]
button.
If you touch the [Reset] button, the display returns
to the screen in Step 2 of "Selecting the Images and
Specifying the Number of Copies to Print"
(page 8).
Also, if you touch the [Additional order] button, all
your operations up-to-date are saved, and the
display returns to Step 2 of "Selecting Media
Where Image Data is Stored" (page 6). From there,
you can select a different output service and
combine the various prices when you are ready to
print. (You can perform this operation up to three
times.)
The following screen appears.
Note
If you used the configuration screen to set printing
without password entry at this step, the print job
starts without displaying this screen, and you can
proceed to Step 2 of "Output" (see below).
2
Touch the [OK] button.
The password entry screen is displayed.
9
GB
Printing Image Data