Sony UPA-PC105 Benutzerhandbücher Seite 22

Note
You cannot perform this procedure to scan
monochrome film.
1 Touch the frame that you want to modify, then
touch the [Scene correction] button.
A screen opens so you can select the level of
correction.
2 Touch the button of the desired level of
correction, then touch the [OK] button.
The correction level is changed and the display
returns to the image selection screen.
4
Make color adjustment settings for scanning, as
necessary.
1 Touch the [Color] button.
A screen opens so you can make color
adjustment settings.
2 Make color adjustment settings.
You can make the following settings on this
screen.
• You can set whether color adjustment is
performed frame by frame or the same
adjustment applied to all the frames. Touch
the [Scope] button to switch between
[Each frame] and [All frames].
• When scanning a color negative or positive,
you can adjust [C], [M], and [Y]. Touch [+]
for stronger hues or [-] for weaker hues.
• When scanning a monochrome negative, you
can adjust [Contrast]. Touch [+] for higher
contrast or [-] for lower contrast.
• Touch [+] next to [Density] for higher density
or [-] for lower density.
22
GB
Scanning and Printing from Film
• When you set [All frames], you can adjust the
sharpness of the scanned images. Touch [+]
for sharper outlines and [-] for fuzzier
outlines. This can be adjusted between [1]
(outlines are not sharpened) and [4] (very
sharp outlines).
• To cancel all adjustments, touch the [Reset]
button.
• Touch the [Apply] button to apply the
adjustments on the image list.
3 When you are done, touch the [Apply] button.
The display returns to the image selection
screen.
Scanning the Film
1
Touch the [OK] button.
Only the image in the selected frame is scanned.
When scanning ends, a message prompts you to
remove the film.
2
Remove the film and touch the [OK] button.
A message prompts you to confirm whether you
want to scan another film.
3
Scan other films, as necessary.
• If you touch the [Yes] button, a message
prompting you to specify a film is displayed.
Proceed to Step 4.
• If you touch the [No] button, the screen allowing
you to specify the number of prints is displayed.
Proceed to Step 1 of "Specifying the Number of
Copies to Print" (page 23).