Sony UPA-PC105 Benutzerhandbücher Seite 10

3
Touch the appropriate keys to enter the password.
If you need to cancel password entry and start
again, touch the [C] button.
Output
1
Touch the [Enter] button in the lower-right corner
of the screen.
The print job starts. If you selected several output
services, they are combined and output.
When all the data is printed, the following screen
appears.
Notes
• If you use the configuration screen to set the unit
to inhibit all other operations during output, this
screen does not appear until all output is
complete.
• If you touched the [Add CD] button in Step 2 of
"Selecting the Images and Specifying the
Number of Copies to Print" (page 8), the
following occurs (depending on the settings made
with the configuration screen).
10
GB
Printing Image Data
– If the unit is set to allow other operations during
printing
When printing is complete, a message appears
prompting you to insert a CD-R. Perform Steps
7 to 9 of "Writing Image Data to a CD-R"
(page 40).
– If the unit is set to inhibit other operations
during printing
When the images to be written to CD-R are
printed, a message appears prompting you to
insert a CD-R. Perform Steps 7 to 9 of "Writing
Image Data to a CD-R" (page 40).
2
Touch the [End] button.
The display returns to the screen in Step 1 of
"Selecting Media Where Image Data is Stored"
(page 6).
Notes
• The [Continue] button appears if the unit is set to
inhibit other operations during printing with the
configuration screen. If you touch this button, the
display returns to Step 2 of "Selecting Where
Image Data is Stored", and the [Previous] button
becomes available. You can also continue using
the images that you printed with other output
services.
• A receipt is printed if a receipt printer is
connected to the unit and settings necessary for
printing receipts have been made with the
configuration screen. However, if you set the unit
to print receipts automatically with the
configuration screen, this button is not available.
When output finishes, the receipt is automatically
printed.
Canceling Printing
This procedure varies depending on the settings made in
the configuration screen. Follow the procedure that
applies to your situation.
If the unit is set to allow other operations during
printing
1 Perform the procedures from Step 2 of "Output"
(page 10) to Step 1 of "Selecting Media Where
Image Data is Stored" (page 6).