Sony UPA-PC105 Benutzerhandbücher Seite 21

Touch the button of the film manufacturer that you
want to select, then touch the [OK] button. If the
name of the manufacturer that you want to select
does not appear on the screen, touch the [Others]
button, then touch the [OK] button.
Prescanning starts and a screen opens to select
images and make scan settings.
Selecting the Images for Output and
Making Scan Settings
Select the images that you want to output from the
prescanned images. Make the necessary scan settings.
• Precisely adjust the scanning position
• Change the frame number of the film
• Adjust colors when scanning
Note
If you are writing image data to CD-R, make settings so
that all the images are written immediately after
prescanning ends. Make the scan settings after
deselecting any images that you do not want to write to
CD-R.
1
Touch to select the image to print.
To cancel the selection, touch the image again. To
select all of the images, touch the [Select All/
Deselect All] button. To select or deselect more
than one image (but not all), touch them
individually, one at a time.
If all the images cannot be displayed on one screen
page, touch the [b] or [B] button to display more
pages.
If you touch the [Rotate All] button, all the images
are rotated 180 degrees counterclockwise (are
turned upside down).
2
Adjust the scanning position precisely and change
the frame number, as necessary.
1 Touch the frame that you want to modify, then
touch the [Adjust] button.
A screen opens so you can adjust the position
and the frame number.
2 Precisely adjust the scanning position and
change the frame number.
• If the position of the image is shifted left or
right, touch the frame of the image that you
want to correct, touch the [Adjust] arrow
buttons to adjust the image, then touch the
[Apply] button.
• If a portion of the leading edge of the film
contains no photo or the frame number on the
film is not read, the actual frame numbers and
output frame numbers may not match when
the images from the film appear with file
names on an index.
In this situation, adjust the frame numbers
with [Define Frame No.]. Touch the frame
that you want to modify, touch the [+] or [-]
button under [Define Frame No.] to change
the number, then touch the [Apply] button.
3 When you are done, touch the [Apply] button.
A screen opens to confirm that the images were
updated.
4 Touch the [OK] button.
The new settings are applied on the image list
and the display returns to the image selection
screen.
3
Change the film scanner's level of color balance
correction, as necessary.
For details about how changing this setting affects
scanning results, refer to the following file
\Document\English\Driver.pdf on the UY-S90/100
driver installation CD-ROM.
Scanning and Printing from Film
21
GB