S-Register (S$) - US Robotics Courier Befehlshandbuch

S-Register (S$)

Wenn Sie den Befehl ATS$ eingeben, zeigt das I-modem einen
Teilüberblick der S-Register-Funktionen an. Weitere Anzeigen, die
durch das Drücken einer beliebigen Taste aktiviert werden, zeigen
die übrigen Register an (siehe Abbildung 13.3).
ats$
HELP, S Register Functions (CTRL-S to Stop, CTRL-C to Cancel)
S0 Ring to Answer On
S1 Counts # of Rings
symbol rate
S2 Escape Code Char
symbol rate
S3 Carriage Return Char
symbol rate
S4 Line Feed Char
symbol rate
S5 Backspace Char
symbol rate
S6 Wait Time/Dial Tone (sec)
symbol rate
S7 Wait Time/Carrier (sec)
Indicate
S8 Comma Time (sec)
S9 Carrier Detect Time (1/10sec)
S10 Carrier Loss Time (1/10sec)
trellis code
S11 Dial Tone Spacing (msec)
trellis code
S12 Escape Code Time (1/50sec)
trellis code
S13 Bit Mapped
trellis cod
1 = Reset On DTR Loss
2 = Do Originate in Auto Answer
4 = No Pause Before Result Codes
8 = Do DS0 On DTR
16 = Do DS0 On Reset
32 = Disable HST
coding
64 = Disable MNP Level 3
deviation
128 = Hardware Reset
S14 Bit Mapped
coding
1 = Escape Code Hang Up
2 = Result Code Orig Only
S15 Bit Mapped
1 = Disable High-Freq EQ
2 = Disable Online Fallback
Server Xmit
4 = Disable 450 Bit/s Back Channel
8 = Reduced Non-ARQ TX Buffer
86 Courier I-Modem Befehlshandbuch
S54 Bit Mapped
1 = Disable 2400
2 = Disable 2743
4 = Disable 2800
8 = Disable 3000
16 = Disable 3200
32 = Disable 3429
64 = Disable V.8 Call
128 = Disable V.8 Mode
S55 Bit Mapped
1 = Disable 8S-2D
2 = Disable 16S-4D
4 = Disable 32S-2D
8 = Disable 64S-4D
16 = Reserved
32 = Reserved
64 = Reserved
128 = Reserved
S56 Bit Mapped
1 = Disable Non linear
2 = Disable TX level
4 = Disable Pre-emphasis
8 = Disable Pre-
16 = Disable Shaping
32 = Disable V34+
64 = Disable V.34
128 = Disable V.FC
S58 x2 Mode and Remote
1 = Disable x2
2 = Disable server