*V1=n
*V2=n
*W=n
OK
Wählbefehle (D$)
Wenn Sie den Befehl ATD$ eingeben, zeigt das I-modem einen
Überblick der Wahloptionen an (siehe Abb. 14.6).
atd$
HELP, Dial Commands (CTRL-S to Stop, CTRL-C to Cancel)
0-9 Digits to Dial
*
Auxiliary Tone Dial Digit
#
Auxiliary Tone Dial Digit
T
Tone Dialling
P
Pulse Dialling
R
Call an Originate Only Modem
,
Pause (Wait for S8 Time)
.
Wait for a Connection
;
Remain in Command Mode After Dialling
W
Wait for 2nd Dial Tone (X3-X7)
@
Wait for an Answer (X3-X7)
OK
nn=1-63 Fixed TEI assignment
Voice Bearer Capability (DN0)
n=0 3.1Khz Audio
n=1 Speech
Data Bearer Capability (DN1)
n=0 Auto Detect
n=1 V.120 Rate Adaption (Fixed)
n=2 V.110 Rate Adaption (Fixed)
n=3 Modem/Fax Emulation (Fixed)
n=4 Clear Channel (external only)
n=5 Auto Mode PPP
n=6 X.75 Rate Adaption (Fixed)
ISDN Switch Protocol Type
n=4 ETSI NET3
n=5 Germany 1TR6
n=6 France VNx
n=7 Japan NTT INSnet64
n=8 Australia TS.013
Abbildung 0.5 Hilfe zu Stern-Befehlen (AT*$ )
Abb. 0.6 Hilfe zu Wählbefehlen (ATD $)
Hilfezeigen
91