Acteon SATELEC EndoDual Benutzerhandbuch Seite 10

The second row shows the:
 Contra-angle reduction rate.
Change Contra-angle reduction rate with "Ratio" and +/- buttons.
 Direction (FWD). (right)
Toggle FWD/REV (beep) with "FWD/REV" button
The third row shows the:
 Speed in use (left)
Change speed with "RPM" and +/- buttons
 Type of "Autoreverse" (right)
Change type of "Autoreverse" with "AR MODE" button (STOP, AR, SAR)
The fourth row shows the:
 Torque value in Ncm
Change value of the set torque with "Ncm" and +/- buttons
 Programming the unit:
1. RATIO: Sets contra-angle reduction ratio. See the available reduction ratio in the following table:
2. SPEED +/-: Sets motor rotation speed. See the following table:
RPM
3. TORQUE +/-: increases or decreases the torque values. Torque values are in Ncm and depend on contra-angle reduction rate. See the
following table with a 16:1 contra-angle:
0.5
1:1 6:1
1:1 6:1
1000 150
1500 200
2000 250
2500 300
3000 350
3500 400
4000 450
4500 500
5000 550
5500 600
6000 650
6500 700
7000 750
7500 800
8000 850
8500 900
9000 950
9500 1000
10000 1100
1200
1300
1400
1500
1600
1 1.5 2 2.5 3
8:1 16:1
Reduction rate
8:1 16:1
125 100
150 150
200 200
250 250
300 300
350 350
400 400
450 450
500 500
550 550
600 600
650
700
750
800
850
900
950
1000
1100
1200
1250
Ncm
3.5 4 4.5 5 5.5
20:1 32:1
20:1 32:1
100 100
120 150
150 175
200 180
250 200
280 250
300 280
350 300
400
450
500
6 6.5 7 7.5 MAX
10