Connecting-up
X2 – Motor
connection
CAUTION
7-6
The motor connection is located at the lower section of the unit.
Terminal
PE2
Protective conductor connection
U2
Phase U2 / T1
V2
Phase V2 / T2
W2
Phase W2 / T3
Connectable cross-section: 4 mm
Terminal PE2 is at the front when installed.
Table 7-2
Motor connection
The motor cables must be dimensioned in accordance with VDE 298,
Part 2.
After installation of the connector, the shield of the motor cable must be
fixed to the shield plate through a large surface area.
The connector has to be screwed firmly to the housing (providing
resistance to vibration and protecting against being inadvertently
withdrawn).
Meaning
3 AC 0 V - 480 V
3 AC 0 V - 480 V
3 AC 0 V - 480 V
²
(AWG 10), stranded
Operating Instructions
06.2005
Range
6SE7087-6KP60
Siemens AG
SIMOVERT MASTERDRIVES