look S96 Montageanleitung Seite 28

GB
Fitting the saddle
to the E-POST ti stem
1 – Position the SLIDE (4) on the head of the
SADDLE STEM (8).
2 – Fit the LOWER CLAMP (3) on to the SLIDE
+ SADDLE STEM assembly.
3 – Place the UPPER CLAMP (2) on the
LOWER CLAMP (3) so that the grooves are at
90 degrees to each other.
4 – Put the SCREW (7) through the SCREW
WASHER (6), then through the OBLONG
WASHER (5), checking that the curved faces
of the two washers slide against each other.
5 – Insert the three items into the STEM+
SLIDE+LOWER CLAMP+UPPER CLAMP
ASSEMBLY and screw on the NUT (1).
6- Fit the saddle rails on to the LOWER
CLAMP (3) then turn the UPPER CLAMP (2),
until the grooves are parallel.
7- Adjust the saddle horizontally using a level
and then fine tune to suit your preferred
position.
8 – Tighten the two assemblies by means of
SCREW (7) with a recommended torque of
22 Nm using a 6 mm hex. key.
28
5
6
7
1: Nut
2: Upper clamp
3: Lower clamp
4: Slide
5: Oblong washer
6: Screw washer
7: Screw
8: Saddle stem
ATTENTION: Never go beyond the "STOP"
mark.
Never fix any stickers to carbon parts.
Cleaning: use only soapy water.
1
2
3
4
8