GB
1. Fit the oblong inserts on the fork in the high (diagram 1) or low (diagram 2) position, as
desired. (Fig. 14)
Fig. 14
Diagram. 1
Diagram. 2
2. Pre-tighten the M6x16 screw to hold
Fig. 15
the inserts in position.
3. Fit the arms and washers on to the
oblong inserts. (Fig. 15)
4. Pivot the arms a little at a time until the
desired position is obtained. The angle
interval is 7.5°.
5. Pre-tighten the M6x35 screw to hold
the arms in position.
25