look S96 Montageanleitung Seite 26

GB
6. Fit the rear clamp. The projections on the
rear clamp must locate in the two grooves on
the back of the arms. (Fig.16)
7. With the rear clamp in place, offer up the
handlebar and front clamp. (Fig.17)
8. Fit the 4 M5x22 screws and tighten with a
torque not exceeding 6 Nm.
9. Then tighten equally the M6x16 and M6x35
screws holding the stem on the fork. The
tightening torque must not exceed 8 Nm.
Fig. 17
Handlebar
Thanks to the four different lengths of stem available and the choice of two starting positions,
a very wide range of adjustments is possible. If necessary, go through the steps for mounting
the stem again, until the desired position is obtained.
26
Front clamp
Assembled arms
with rear clamp
M6x35 screw
M6x16 screw
Rear clamp
Align the projections
in the rear clamp with
the grooves in the
right and left arms
Composite arm
Fig. 16
4 M5x22 screws
NOTE: When fitting a 26 mm diameter handlebar,
use the reducers supplied with the stem. Position
them inside the collar, so that they fit in between
the collar and the handlebar.