Assembling The Adapter Plate To Avantgarde T, Vr And Start Plus - Ottobock e-support Bedienungsanleitung

Mounting Instructions for the Adaption of the "e-support" to the Avantgarde SL, V, TR, D, CV, CS, or Start Plus
2.2 All other Types of Side Panels
2.3 Control
3..Assembling.the.adapter.plate.to.Avantgarde.t,.VR.and.start.Plus
e-support
Mount the adapter plate to the inside of the wheelchair. For each rear wheel,
screw one spacer into the threaded bore shown in figure 3.
Position the fitting in a way that is protrudes maximally from the adapter plate.
The Nordlock washers are placed between the outer surface of the adapter
plate and the counternut.
1) Check the position of the "e-support" rear wheels in relation to the side pa-
nels! Is the position of the fittings correct?
2) Are the spacers mounted to the correct threaded bore?
INFORMAtION
When in correct position, the spacers point centrically toward the wheelchair
frame (see figure 5).
Spacer
on the frame
Always assemble the adapter plate to these models on the outside of the fra-
me. To check if adapter plate is correctly assembled, refer to the preceding
chapters. The position of the fitting in the adapter plate must be checked and if
necessary should be re-positioned. The height of the fitting to the adapter plate
is 15 mm. The Nordlock washers are assembled on the inside (see picture 6).
6
Ottobock | 67