Battery Fault Indications; After Charging - Ottobock e-support Bedienungsanleitung

How to Check the Battery Capacity
4..Battery.Fault.Indications
When the battery has an internal fault or the battery temperature is not suitable for use, the condition will be notified
by the battery capacity indication lamps.
➜ Internal fault of battery
• Lamp 4 will blink. Consult with the dealer.
• Although charging cannot be performed, operation is possible until the battery is completely discharged.
➜ Inappropiate battery temperature
• Lamps 1, 3, and 5 will blink. Although operation is possible, the remaining capacity in the battery will not be indica-
ted. It is recommended that the wheelchair not be used until the battery reaches a suitable temperature.
• When the battery has reached a suitable temperature, the lamps 1, 3, and 5 will stop blinking and will return to
indicating the battery capacity.
➜ Battery.fuse.blown.out.or.contact.point.failure
• Lamp 3 will blink. Refer to page 23 "Problems during Charging" or page 20 "How to Charge the Battery" for de-
tails.
Protection cap
62 | Ottobock
5..After.charging
1) When charging has been completed, remove the charged battery.
.AVeRtIsseMeNt
Store the detached battery with the protective cap on. There is a danger of a
short-circuit when the connecting portion is exposed.
2) Unplug the power cord from the outlet by holding the plug portion.
.AtteNtION
Do not pull on the power cord. This can cause breakage to the wires.
3) Storing the battery for a long period
If the battery is stored for a long period, the battery capacity will decrease due
to self discharging. Before using it, recharge any battery that has not been in
use for over one week.
4) Recycling the battery
Dead batteries are valuable resources that can be recycled. Contact the dea-
ler shop when asking for recycling.
e-support