P Roblems During Charging - Ottobock e-support Bedienungsanleitung

Inspection and Adjustment
4..Problems.during.the.charging.process
If a problem occurs with the battery or the charger during charging, the "Charging" lamp and the "Refresh" lamp on
the charger, and the battery capacity display lamps, light to alert the user to the problem.
the.charging.display.on.the.charger.flashes.(standby.mode)
the.charging.lamp.and.the.refresh.lamp.of.the.charger.blink.simultaneuosly
the.fourth.battery.capacity.lamp.blinks.
the.charging.lamp.and.the.refresh.lamp.of.the.charger.blink.alternately.at.a.fast.rate.(1.second.intervals).and.
the.third.battery.capacity.lamp.blinks
❍ ❍
Battery fuse
Spare fuse
the.first,.third.and.fifth.LeDs.on.the.battery.capacity.indicator.are.flashing.
the.charging.lamp.and.the.refresh.lamp.of.the.charger.blink.alternately.at.a.slow.rate.(2.second.intervals)
58 | Ottobock
This indicates that the battery temperature is too high or low for charging.
Please see Section 3.1 "Rapid Charging Procedure".
This indicates an internal fault of the battery. Please replace the battery
with a new one.
This indicates an internal fault of the battery. Please replace the battery
with a new one.
• A contact point fault may have occurred. Inspect for clogging by debris,
etc. between the terminals of the battery and those of the charger and
if there is any, remove the debris, etc. Also, if a contact point is covered
with dust, wipe it off with a dry cloth, while being careful not to deform or
damage the contacts.
• The battery fuse may be blown out. Open the fuse lid at the side of the
battery and inspect the fuse. If the fuse is blown out, replace it with the
spare fuse which is attached to the protection cap.
.AVeRtIsseMeNt
Since there is danger of fire, etc., use only the designated fuse (20 A
blade fuse) for the battery, never use a wire, etc. in place of the desi-
gnated fuse.
The battery temperature is not suitable for charging. Wait until the battery
reaches an appropiate temperature, and then start charging.
There is a fault in the charger. Replace the charger with a new one, and
then perform charging.
e-support