How.to.attach.and.remove.the.wheels; Removing The Wheels; Attaching The Wheels - Ottobock e-support Bedienungsanleitung

how.to.Attach.and.Remove.the.Wheels

Use the following procedure to attach and remove the wheels (removable type).
1..Removing.the.Wheels
Protection cap
Coupler
2..Attaching.the.Wheels
e-support
(1) Detach the battery so the power will not turn on during operation.
.AVeRtIsseMeNt
store.the.detached.battery.with.the.protective.cap.on..there.is.a.danger.
of.a.short-circuit.when.the.connecting.portion.is.exposed.
(2) Pull off the coupler of the left wheel by slightly turning the end.
INFORMAtION
Wind the removed coupler to the right wheel to prevent it from being dama-
ged.
(3) Lift the cam shaft lever on the left wheel. Pull the lever and remove the
wheel.
INFORMAtION
When the left wheel is removed, the remaining right wheel and the wheelchair
body are light enough to be carried as a unit. Load the wheelchair in the car if
it is not necessary to remove the other wheel.
(4) If necessary, remove the right wheel by following the same procedure.
.AtteNtION
Remove the wheel by holding onto the battery storage so the wheel will not
spin. Depending on the circumstances, the battery and other components may
be damaged if the wheel spins when it is removed.
Insert the axle end to the frame mounting portion with the cam shaft lever of
the left wheel lifted. Then match the torque stop portion and fit the wheel in
place.
Mount the right wheel by following the same procedure.
Push in the coupler by matching the portion (white) of the coupler to the mark
on the insert inlet.
How to Attach and Remove the Wheels
Ottobock | 51