Application; Liability; Range.of.application; Ce.conformity - Ottobock e-support Bedienungsanleitung

Application | Liability | Range of Application | CE Conformity | Introduction | Symbols used in this Manual

Application

The servo-assisted e-support power-assist accessory is designed solely for people who are unable to walk or who
have a walking impediment. The wheelchair can be moved either by the patient themself or by another person.

Liability

The manufacturer's warranty applies only if the product has been used under the conditions and for the purposes de-
scribed. The manufacturer recommends that the product be used and maintained according to the instructions for use.
The manufacturer is not responsible for damages caused by components and spare parts not approved by the ma-
nufacturer. Repairs must be carried out exclusively by authorized dealers or by the manufacturer.

Range.of.Application

The e-support is a servo-assisted power-assist accessory for manual wheelchairs. It is operated by moving the push
rings. This principle improves the user's mobility by amplifying the remaining residual forces of the wheelchair user.
This system has been designed to be used by patients with walking impediments / inability with low arm forces due to:
• Palsies
• Paralysis
• Loss of limbs (lower limb amputation)
• Defective / deformed limbs
• Joint contractures / defects
• Diseases like cardiac / circulatory insufficiency, balance disorders, or cachexia
• Multiple sklerosis
• Muscular dystrophy
• Geriatrics
The e-support is mounted to the wheelchair in exchange for the existing rear wheels.
This system was specially designed for individuals who will be able again to independently move in a whelchair due
to this additional support.
Fitting considerations:
• Body height and weight (max. load is 125 kg (275 lbs.))
• Physical and psychological limitations

ce.conformity

Ottobock as manufacturer with sole responsibility declares that the e-support in combination with the approved This
product meets the requirements of the 93/42/EWG guidelines for medical products. This product has been classified
as a class I product according to the classification criteria outlined in appendix IX of the guidelines. The declaration
of conformity was therefore created by Ottobock with sole responsibility according to appendix VII of the guidelines.

Introduction

Thank you very much for purchasing the e-support. The e-support is operated by using the push rings, in the same
way as a manual wheelchair. However, there are several operational aspects which differ from those of a manual
wheelchair due to the Power Assist System. Generally speaking, when riding in a wheelchair, there is a potential dan-
ger of injury or damage to the wheelchair from misuse, depending on the road surface or traffic conditions. Traveling
unaccompanied may be very dangerous, depending on the conditions and the disabilities of the rider. Before using the
wheelchair, be sure that both rider and attendant read this manual thoroughly, to assure safe and comfortable use.

symbols.used.in.this.Manual

Items concerning proper handling are indicated with the following symbols.
.AVeRtIsseMeNt
.AtteNtION
INFORMAtION
36 | Ottobock
• Age of the user
• Home conditions and environment
Indicates that misuse may lead to death or severe injury.
Indicates that misuse may lead to injury or material da-
mage.
Indicates proper operation and points regarding inspec-
tion and maintenance.
This symbol indicates things you must not do.
This symbol indicates that it is necessary to be accompa-
nied by an attendant.
e-support