Side Panel With Armrest; Fig. 6 Removing The Side Panel; Fig. 7 Adjusting The Height Of The Armrest - Otto Bock B500-S Bedienungsanleitung

7.1.2 Side Panel with Armrest
The side panels can be removed by loosening the thumb
screws and lifting the side panels. If the control panel is
attached to the armrest, it must be disconnected before
taking out the side panel (section 7.1.3).
The thumb screws are located at the lower end of the
armrest holders (see arrow in fig. 6).
fig. 6 removing the side panel
After remounting the side panel, do not forget to firmly
retighten the thumb screws.
The height of the armrest can be changed by loosening
the screw (see arrow in fig. 7).
B500 | B500-S
fig. 7 Adjusting the height of the armrest
Firmly re-tighten the screws after making adjustments.
03/2010
Operation
Page 105