6.14 Setting rear wheel tracking (M5) (Fig. 34, 35)
The correction plate, which is angled twice, is to be mounted to the adapter with the rear wheel
fitting and the camber washers. To correct wheel tracking, put the level on the straight edge of
the correction plate and turn the plate until the camber washers are level. Next, fix the plate with
the 6 mm oval head screw. Finally retighten the M18x1 nuts.
INFORMATION!
Make sure to firmly retighten all screws and nuts after making adjustments.
Observe the values indicated in section 6.1.
56
34
35