Otto Bock M1 Intro Bedienungsanleitung Seite 61

Mounting (Fig. 36)
• Place the protective rim band over the valve. Then push the valve through the rim. Screw on
the valve nut, if there is one. The rim band can then be easily applied.
• Ensure that all spoke ends are covered.
Tires (Fig. 37)
• Beginning behind the valve, place the lower side of the tire over the edge of the wheel rim.
Pump the tube with a small amount of air until it is round. Then insert it in the tire.
• Check the inner tube for folds. If folds are present, release some air. The rest of the tire can
then be mounted by, starting with the section of tire opposite the valve, gently pressing the
tire toward the valve.
Inflating
• Check around the tire on both sides to ensure that the tube is not clamped between the edge
of the tire and the rim.
Push the valve back slightly and then pull it out again such that the tire is well-seated in the
valve area.
• Inflate the tire until it can still be pressed easily with your thumb. If the control line on both sides
of the tire is equally distanced to the rim, the tire sits centrally. If the tire does not sit centrally,
let out some air and realign the tire. Then inflate the tire to the pressure indicated on the side
wall and tighten the dust cap.
36 37
59