Abicor Binzel iCAT Betriebsanleitung Seite 49

iCAT WH
NOTE
• Observe the information given in section
 8 Putting out of operation on page EN-21.
1 Dismounting the cable assembly
 6.4 Replacing the cable assembly on page EN-17
2 Dismount the iCAT WH from the robot.
 6.3 Fastening the iCAT WH and cable assembly to the robot on page EN-15
12 Disposal
For disposal, observe the local regulations, laws, provisions, standards and guidelines. For the
product to be properly disposed of, it first must be dismounted.
 See 11 Dismounting on page EN-24
12.1 Materials
This product is mainly made of metallic materials which can be melted in steel and iron works
and are, thus, almost infinitely recyclable. The plastic materials used are marked in preparation
for sorting and separation of the materials for later recycling.
12.2 Consumables
Oil, grease and cleaning agents must not contaminate the ground or enter sewage systems.
These materials must be stored, transported and disposed of in suitable containers. Observe the
relevant local regulations and disposal instructions of the safety data sheets specified by the
manufacturer of the consumables. Contaminated cleaning tools (brushes, rags, etc.) must also
be disposed of in accordance with the information provided by the manufacturer of the
consumables.
12.3 Packaging
ABICOR BINZEL has reduced the packaging for shipping to a minimum. Packaging materials
are always selected with regard to their possible recycling ability.
12 Disposal
EN - 25