Troubleshooting - Abicor Binzel iCAT Betriebsanleitung

iCAT WH
9.2 Cleaning the clamping cylinder
1 2 3
5
1 Pneumatic connection
2 Cover
Fig. 13 Cleaning the iCAT WH ROBO WH
1 Unscrew clamping cylinder from the iCAT
2 Unscrew the pneumatic connection (1)
3 Unscrew the cover (2).
4 Blow compressed air through the individual parts.
5 Check the O-rings (6) for wear and replace them if necessary.
6 Grease the piston (4) and O-rings (6) with sealing grease (included in the scope of
delivery).
7 Mount clamping cylinder again

10 Troubleshooting

DANGER
Risk of injury and machine damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and dam-
age to the device. The product warranty will be rendered invalid if the unit is handled by
unauthorized persons.
• Operating, maintenance, cleaning and repair work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
NOTE
• If the measures described below are not successful, please consult your dealer or the
manufacturer.
• Please also consult the operating instructions for the welding components, such as the
power source, welding torch system, re-circulating cooling unit, etc.
4 2
3 Housing
4 Piston
10 Troubleshooting
1 5 4
6
5 Connection seat
6 O-rings
3
EN - 23