O) Rudder Linkages - Reely Piper Cherokee Bedienungsanleitung

o) Rudder Linkages

Assemble the rudder horn (1) on the elevator so that the series of holes is in a
line with the rotary axis on the rudder. (See Fig. 43)
Screw the rudder horn to the counter plate (2) and clip off the protruding screws
with the wire cutters.
Follow the same procedure for the rudder horn of the rudder.
Open the cutout to enable the linkage to pass through the fuselage (1).
Thread the pushrod (2) through the opening from inside and screw the fork
head (3) onto the linkage until it is level with the linkage.
Suspend the fork head in the rudder horn (4).
Follow the same procedure for the rudder linkage of the rudder.
Figure 42
Figure 43
Figure 44
47