C) Installing The Aileron Servo Tray; D) Wing Retainer - Reely Piper Cherokee Bedienungsanleitung

c) Installing the Aileron Servo Tray

Place the aileron servo tray (1) and corresponding brackets (2) exactly between
the markings you made.
Make sure a long bracket is laid out for the front side and a short one for the
rear; do not get them the mixed up!
Sketch the contours out with a marker. Next, use a cutter to cut out the holes in
the upper part of the wing as shown in the illustration.
First of all, glue the two brackets (2) vertically into the designated slots. Next,
glue the servo tray (1) from above.
Be careful not to leave a gap between the parts.

d) Wing Retainer

Glue the two wing retainers (1) into the designated holes with 5-minute epoxy
resin (2).
Make sure the retainers are pushed as far as possible into the hole.
Wipe off any excess glue before it can dry onto the surface.
36
Figure 9
Figure 10
Figure 11