Reely Piper Cherokee Bedienungsanleitung Seite 38

Use a cutter to remove the film between the lines (1) with a clearance of 5 mm.
Make sure you only cut the film and not the wood beneath it.
Apply 5-minute epoxy resin to the adhesive surface and place the tail assembly
in exactly the same position you marked out with the marker.
To achieve a visually pleasing transition between tail assembly
and shaping, we recommend you attach a strip of white adhesive
tape (1).
Proceed in just the same way with the rudder as with the elevator described
above.
Make sure that the rudder is at exactly 90° to the elevator.
38
Figure 15
Figure 16
Figure 17