h) Assembling the Main Undercarriage
Use a cutter to pierce the undercarriage groove (1).
Put the undercarriage wire (2) into the groove and screw two support plates (3)
into the wing from above.
Use a mini-drill to bore the holes of the screws for the support
plates.
i) Assembling the Bow Undercarriage
Slide the collar (1) onto the bow undercarriage (2) and screw it tight.
Next, place the spacer (3) onto the bow undercarriage (2).
Push the unit through the landing gear suspension so that it comes into contact
with the motor mounting plate; attach the control lever (4) above and screw it
tight as well.
Thread the pushrod (5) for the bug undercarriage in the control
lever before it is screwed onto the undercarriage.
40
Figure 21
Figure 22
Figure 20
Figure 21
Figure 23