L) Assembling The Aileron Linkage - Reely Piper Cherokee Bedienungsanleitung

l) Assembling the Aileron Linkage

Assemble two linkages as shown in the illustration.
Screw the fork heads (1) along the linkage until the rear linkage is level with the
fork head.
Screw the rudder horns (1) until the upper linkage (2) is level with the rudder
horn.
Assemble the aileron servo (1) in the wood frame as shown in the illustration.
You may need to make a small groove in the wooden frame to
allow the servo cable to pass through.
Suspend the fork heads (2) in the rudder horns of the aileron linkage (3). Make
sure that the rudders are in neutral.
44
Figure 33
Figure 34
Figure 35