q) Installing the Switching Harness
Install the switching harness in the fuselage on the opposite side to the muffler
exhaust. This will prevent oil or other exhaust particulates from damaging the
switch.
Use the switch frame (1) as a template for cutting the necessary cutouts (2) in
the fuselage.
r) Assembling the Wings
Place the wings on the fuselage. Align the wings as shown in Figure 50 and
use a small drill to drill the mounting holes (1) in the wing.
Fasten the wing with the two enclosed screws.
Figure 48
Figure 49
Figure 50
49