N) Installation Of The Servo - Reely Piper Cherokee Bedienungsanleitung

Cut the ABS parts for the cockpit projection to approx. 145 x 120 mm and
slowly adapt to the optimal fit.
To do so, push the polystyrene parts into the cockpit from underneath.
Once you are pleased with the shape of the projecting pieces, you can then
glue them in the cockpit with 5-minute epoxy resin.
To give the model even more verisimilitude, you can also add
flight instruments, miniature pilots or other fittings in this phase of
construction.

n) Installation of the Servo

Use wood glue to glue the servo tray (1) into the fuselage as shown in the
illustration.
Assemble the servos (2) in the designated cutouts.
Our tip:
Use a small drill to drill the holes for the servo screws this will
ensure you do not split the servo tray.
46
Figure 39
Figure 40
Figure 41