Emptying The Grass Catcher - EMAK efco BLE 506 Betribs- Und Wartungsanleitung

5.6 | EMPTYING THE GRASS CATCHER

The full level of the grass catcher is signalled by the full grass catcher flap. It is possible to regulated the full level of the
grass catcher by moving the sliding part of the flap (extending or shortening the arm) and thereby optimise its filling up
for various types of collected vegetation (dry grass, wet grass, leaves, etc.).
(1) Sliding part extended = grass catcher filled to minimum
(2) Sliding part retracted = grass catcher filled to maximum
Procedure for emptying:
► Drive the machine to the location where you wish to empty the grass catcher. Stop the machine and apply the brake. If on a slope,
use the parking brake.
► Disengage the mowing deck by pushing down the engagement switch.
► If the AUT/MAN switch is installed on the machine, leave this switch in position "AUT".
► Set the throttle lever to position "MIN".
► Slide the grass catcher dump lever handle completely upwards (1) and tilt it down (2) to tip out the grass catcher,
allow it to empty freely, slowly release it and tilt it back.
51
5.6a
5.6b