Mounting The Rear Wheels - EMAK EF 95 Montageanleitung

- assembly of the grass catcher
- mounting of the sensor rollers on the
mower mechanism
- connect the battery

MOUNTING THE REAR WHEELS

(20'' tyres only)
1. Pull the rear of the tractor in the
direction of a rear wheel until you can
hear it make contact with the rim (1).
2. Remove the factory-fitted rubber O-ring
(2).
Note: The O-ring only prevents loss of
the feather key during transport and is
GB
not used any further.
3. Push a Ø 19 x 42 washer (3c) onto the
axle.
4. Insert the lock washer (3b) into the shaft
groove in front of the washer, and press
it into the groove until it engages.
5. Press the cover cap (3a) onto the hub.
6. Pull the rear of the tractor in the
direction of the other rear wheel until
you can hear it make contact with the
rim.
7. Remove the factory-fitted rubber O-ring.
8. Push a Ø 19 x 42 washer (3c) onto the
axle.
9. Insert the lock washer (3b) into the shaft
groove in front of the washer, and press
it into the groove until it engages.
10. Press the cover cap (3a) onto the hub.
MOUNTING THE STEERING WHEEL
1. Set the front wheels to the to the
straight-ahead position.
2. Place the clamping sleeve (4a) on the
steering column.
3. 3 Place the steering wheel (4b) on the
clamping sleeve.
Note: Make sure the position is correct
with the spoke pointing towards the
operator.
4. Insert the washer (4c) and the cup spring
(4d).
5. Fasten the steering wheel (4b) using the
hexagon bolt (4e).
Make sure the tightening torque is 20
Nm. Use a torque wrench.
12
6. Put on the cover (4f ).
MOUNTING THE OPERATOR'S SEAT
1. Remove the shaft fastener (5a) from the
seat (5c).
2. Pull out the shaft (5b).
3. Pass the shaft back into the seat (5c) and
reinstall the shaft fastener (5a).
4. Connect the seat contact switch (6a).
5. Attach the cable (6b) of the contact
switch (6a) to the lug (5d) using cable
ties.
HOOKING IN THE FILL-LEVEL
SIGNAL TRANSMITTER OF THE
GRASS CATCHER
Hooking in the fill-level sensor of the
grass catcher
The fill-level sensor uses a horn to signal
when the grass catcher must be emptied.
The grass catcher must be removed in order
for the fill-level sensor to be fitted.
1. Push the fill-level sensor (26a) into the
opening in the rear wall. Make sure the
fill-level sensor is in the correct position.
2. Push it into the opening straight and
without excessive force, until you can
feel it engage.
ASSEMBLING GRASS CATCHERS
Use a battery-operated screwdriver
with a Torx bit TX30 for assembly.
1. Insert the support plate in the bottom
part of the grass catcher on both sides
(7).
2. Guide in horizontally and swivel upwards
(8, 9 and 10)
3. Clamp the front support strut (11a) into
the lower part of the grass catcher (11b)
and use M6x35 carriage bolts, washers
and self-locking nuts to screw on from
the outside (12).
4. Screw the top part of the frame (13a)
firmly onto the support strut using
M6x35 carriage bolts, washers and self-