Replacing A Fuse; Sharpening The Blades - EMAK efco BLE 506 Betribs- Und Wartungsanleitung

- Always use only the spark plug specified by the engine's manufacturer!
- If the engine was running shortly before the inspection or replacement, then the spark plug will be very hot. So be very careful not
to burn yourself.
► Take off the spark plug cable and remove the spark plug using a wrench key.
► Visually inspect the exterior appearance of the spark plug. If the spark plug is visibly significantly
worn out or if the insulator is cracked or it is peeling, it is necessary to replace it.
► If the spark plug is soiled or only slightly worn, it is necessary to carefully clean it with a suitable wire
brush (copper).
► Using a gauge measure set the distance of the electrodes (
► After performing maintenance on or replacing the spark plug, pull it tight in position. An incorrectly
tightened spark plug heats up significantly and may cause serious damage to the engine.
Check, maintain and replace spark plugs according to the instructions contained in the user's manual for the engine supplied by its
manufacturer.
► REPLACEMENT OF THE FUEL FILTER
Never allow the engine to run without an air filter. This rapidly wears out the engine.
Replace the fuel filter according to the instructions contained in the user's manual for the engine supplied by its manufacturer.
6.3.3REPLACING LIGHT BULBS
Light bulbs are seated in a reflector and are accessible after lifting the hood. The individual types of light bulbs are as follows:
Type of light bulb:
Halogen light bulbs 10W / 12V
► When replacing thehalogen light bulbs first press the tab (1) and slide the bulb out of the socket (2). For installation
proceed in the reverse sequence.
6.3.3

6.3.4 REPLACING A FUSE

If a fuse is damaged the engine will immediately shut off, the mowing deck will stop and all
indicator lights on the dash board will turn off. In this case it is necessary to find the faulty
fuse and replace it with a new one. Under no circumstances should you replace a faulty fuse
with a fuse that has a higher current rating!
Fuses are accessible after removing the battery cover located under the steering wheel and
removing the fuse cover.
► Remove the fuse and insert a new fuse with the same rating as the initial fuse, i.e. 15A or
10A. If even after replacing the fuse the engine or the mowing deck will not work, contact
an authorised service centre.
► Certain machine models are equipped with a central switchboard. Under no condition
should you tamper with the switchboard! The only exception is the replacement of fuses.
6.3.5 LIFTING THE MACHINE
If you wish to lift the riding mower, use a jack and supports.
Proceed as follows:
► Place the jack underneath the gear box on the rear axle and lift the rear part of the machine.
► Insert two supports underneath the ends of the axles from the inner side of the rear wheels.
► Lift the front part of the machine and insert two supports under both ends of the front wheel axles.
Never lean the machine to the side where the carburettor is located. Oil could enter the air filter!
6.3.6 MOWING DECK - SHARPENING AND REPLACING THE BLADES

► SHARPENING THE BLADES

The mowing blades must be sharp, statically balanced and straight. Blunt, incorrectly sharpened or damaged mowing blades cause
grass to be torn out of the ground, damage to lawns and mediocre collection of mowed grass in the grass catcher.
Do not repair a blade that is deformed or otherwise damaged, replace it immediately.
Whenever handling the mowing blades, always use heavy-duty work gloves.
User's manual for the engine).
Socket/reflector:
Reflector M Light, type HLRG-510F,
diameter 51 mm (cap GU5.3)
56
0,7 - 0,8 mm
Replace with:
M light type HSS-510
or equivalent of another manufacturer